The Special Communications System [SCS] permits direct, automated, real-time communications in support of joint forces requiring rapid deployment or redeployment. SCS terminals send and receive record narrative messages over a 5 kHz, narrowband satellite channel. The SCS operates in the UHF spectrum using the 225 to 400 MHz band.The Army, Navy, and Air Force operate SCS terminals. They consist of satellite communication terminals AN/GSC-40, AN/GSC-40A(V)l, AN/GSC-40A(V)2, and AN/MSC-64(V)2. The SCS terminal, AN/MSC-64(V)2, is a highly mobile set installed in an S-280 type shelter. The rack-mounted combined ground command post terminal (CGCPT)AN/GSC-40(*)(V)(*)is configured to the needs of the fixed site at which it is installed. SCS terminals are deployed in Europe and Korea. All Army terminals function within a TACSAT network made up of force terminals (FTs)and command post (CP)equipment.
All SCS terminals deployed in a theater are operated as a network. The US Pacific Air Force has operational responsibility for all Air Force SCS terminals in the Korean theater. The US Army provides off-site maintenance support for US Air Force terminals in the Korean theater. Within joint commands, the US Army component commands are responsible for operation and maintenance of the SCS terminals assigned to their subordinate units.
c. SCS terminals deployed to Europe and Korea support Army, Navy, and Air Force real-time communication requirements for on-going special missions.
The SCS terminal is a single-channel TACSAT set. Each SCS terminal uses an I/O device. The device has a keyboard and display for editing and composing narrative traffic. The keyboard and display equipment is the I/O unit MX-10159/G that functions as the sole subscriber data terminal equipment (DTE). The AN/MSC-64(V) and AN/GSC-40(V) are self-contained terminals.
A high degree of network flexibility is accomplished by using a TDMA control structure and a CGCPT. This technique allows communications to be executed on a time-shared basis between other terminals within the theater network. The terminal can operate in the random or time division multiplexing (TDM)modes. The random mode of operation allows the user to enter the TACSAT communications network on a random basis using an open selected channel.
The AN/GSC-40(V)performs the network control function (NCF)for a net of AN/MSC-64(V)FTs.
The NCF, normally located within a CP, performs the following subnet control actions:
The FTs perform the following control actions:
The SCS uses FH emission techniques as an ECCM capability and terminal hardening against the effects of EMP. The CGCPT uses wideband operation of coded m-ary FSK, pseudorandomly generated, suppressed carrier RF burst that is frequency hopped. This type of RF emission provides excellent ECCM protection for discrete addressing, message privacy, and multiple addressing. For narrowband operation, noncoherent FSK is used.
Wideband operation is only used between the CGCPT and the National Command Authority AFSATCOM terminals. SCS, a UHF system, lacks any antijamming protection to the TACSAT terminal outside of the emission techniques listed previously. The short transmission times of burst communications present less attractive jamming targets than do longer continuous communications of regular nets. The only options available to TACSAT UHF terminals, in addition to short burst communications, are alternate frequency selection and mobility.